ASROCK J4005DC-ITX User Manual page 19

Serial ATA3 Connectors
(SATA3_1:
see p.5, No. 12)
(SATA3_2:
see p.5, No. 15)
SATA Power Connector
(SATA_PWR_1)
(see p.5, No. 10)
USB 3.1 Gen1 Header
(19-pin USB3_1_2)
(see p.5, No. 14)
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.5, No. 13)
1. High Definition Audio supports Jack Sensing, but the panel wire on the chassis must
support HDA to function correctly. Please follow the instructions in our manual and
chassis manual to install your system.
2. If you use an AC'97 audio panel, please install it to the front panel audio header by
the steps below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for the HD audio panel only. You don't need to
connect them for the AC'97 audio panel.
E. To activate the front mic, go to the "FrontMic" Tab in the Realtek Control panel
and adjust "Recording Volume".
14
These two SATA3
connectors support SATA
data cables for internal
storage devices with up to
6.0 Gb/s data transfer rate.
Please connect a SATA
power cable.
There is one header on
Vbus Vbus
Vbus IntA_PB_SSRX-
this motherboard. This
IntA_PA_SSRX- IntA_PB_SSRX+
GND
IntA_PA_SSRX+
USB 3.1 Gen1 header can
GND IntA_PB_SSTX-
IntA_PA_SSTX-
IntA_PB_SSTX+
support two ports.
IntA_PA_SSTX+ GND
GND IntA_PB_D-
IntA_PA_D- IntA_PB_D+
IntA_PA_D+
Dummy
1
This header is for
GND
PRESENCE#
MIC_RET
connecting audio devices
OUT_RET
to the front audio panel.
1
OUT2_L
J_SENSE
OUT2_R
MIC2_R
MIC2_L