Listening To The Radio; Configuring And Saving Radio Stations; Calling Up Saved Stations - Tchibo 327408 Instructions For Use And Warranty

Listening to the radio

1. Slide the On/Off switch on the back of the device to ON.
2. Press the volume dial, several times if necessary, until a frequency
and FM are shown on the display.
In radio mode, the set frequency fades and is replaced by the current time.

Configuring and saving radio stations

You can read the set frequency on the display.
Automatic station scanning with automatic station memory
Start an automatic station scan by pressing and holding
for approx. 2 seconds.
The device scans frequencies for stations and stores these in the
memory locations P-01 to P-20. Stations previously stored at that
location are overwritten.
Once the scan is complete, the device switches to memory location
P-01.
Automatic station scanning and manually storing stations
1. Start an automatic station scan by pressing and holding either
(scan upwards) or
/ SCAN+
2 seconds.
2. The scan stops as soon as a station is located.
3. To save this station, press
P-01 flashes on the display.
4. Briefly press to save the station. Stations previously
/ PRESET
stored at that location are overwritten.
/ AUTO SCAN
(scan downwards) for approx.
/ SCAN-
for approx. 2 seconds until
/ PRESET
• If you wish to save stations manually, the device will first suggest
memory location P-01, even if a station has already been auto-
matically stored to this location.
• If all memory locations are occupied, memory location P-01
is once again suggested and overwritten if necessary.
Fine-tuning the station frequency
Fine-tuning of the station frequency can be done in 0.5 MHz steps.
Briefly press
/ SCAN+
or down.
If a station cannot be received clearly (too much static), try
adjusting the position of the antenna.

Calling up saved stations

1. Press the button.
/ PRESET
The current memory location will be displayed for a few seconds.
2. While it is being displayed, press
another memory location.
24
or to adjust the frequency up
/ SCAN-
or
/ SCAN+ / SCAN-
to call up