Napoleon BUILT-IN Series Owner's Manual page 23

Possible causes
Possible spider web or other debris.
Improper air shutter adjustment.
Lack of gas
Supply hose is pinched.
Propane regulator in low flow state.
Infrared Burner Flashes Back
• During operation the burner abruptly makes a loud whoosh sound, followed by a continuous blow-torch type sound and
grows dim or has a large flame on start up.
Possible causes
Ceramic tiles overloaded with grease drippings and build-
up. Ports are clogged
Burner overheated because inadequate ventilation. Too
much grill surface covered by griddle or pan.
Leaking gasket surrounding the ceramic tile, or a weld
failure in the burner housing.
Improper heating.
Excessive grease and ash build on sear plates and in drip
pan.
Peeling Paint
• Paint appears to be peeling inside lid or hood.
Possible causes
Grease build-up on inside surfaces.
Napoleon.com | BUILT-IN Series
N415-0601_Built In (Book).indb 23 N415-0601_Built In (Book).indb 23
Solution
Thoroughly clean nest or webs out of your burner orifice by
removing it and following instructions in this manual.
See "Leak Test".
Open or close air shutter slightly according to this manual.
See "Maintenance Instructions".
IMPORTANT! This must be done by a qualified gas installer.
Check gas level in propane cylinder.
Reposition supply hose as necessary.
Turn the burners off and close the tank valve, wait a minute before
fully re-opening the valve, allow a few seconds for the pressure
to equalize before following the Lighting Instructions to start the
grill. Ensure igniting procedure is followed carefully every time you
cook. All gas valves must be OFF when the tank valve is turned
on. Always open the tank valve slowly.
Solution
Turner burner OFF and allow to cool for at least 2 minutes.
Reignite burner and burn on HIGH for at least 5 minutes, or until
the ceramic tiles are evenly glowing red.
Ensure no more than 75% of the grill surface is covered by
objects or accessories. Turn burner OFF and allow to cool for at
least 2 minutes. Reignite.
Allow burner to cool and inspect very closely for cracks. Contact
your authorized Napoleon dealer to order replacement burner
assembly if any cracks are found.
Preheat grill with both main burners on high for 10 to 15 minutes.
Clean sear plates and drip pan regularly. Do not line pan with
aluminum foil. Refer to "Cleaning Instructions".
Solution
This is not a defect. The finish on the lid and hood is porcelain
or stainless steel and will not peel. The peeling is caused by
hardened grease, which dries into paint-like shards, that flake off.
Regular cleaning will prevent this. See "Cleaning instructions".
WE WANT
TO HELP!
Napoleon is here to
ensure your grilling
experience is memorable.
Contact us if you require
additional help.
REGISTER
YOUR GRILL!
Register your grill! Go
to Napoleon.com or
your Assembly Guide
for replacement parts
instructions.
Troubleshooting |
2/11/2021 3:38:56 PM 2/11/2021 3:38:56 PM
23