Troubleshooting - Napoleon BUILT-IN Series Owner's Manual

Troubleshooting

Lighting Problems
• Main, rear or side burners will not light with the igniter, but will light with a match.
• Burners will not cross light each other.
Possible causes
JETFIRE
Dirty or corroded cross light brackets.
Dead battery, or installed incorrectly.
Loose electrode wire or switch terminal wires.
Lifting flames on burner.
Noises and Flare-ups
• Humming regulator.
• Excessive flare-ups and uneven heat.
Possible causes
Normal humming noise on hot days.
The cylinder valve was opened too quickly.
Sear plates installed incorrectly.
Improper heating.
Excessive grease and ash build on sear plates and in drip
pan.
Gas Flow
• Low heat or low flame when valve is turned to high.
• Burners burn with yellow flame, accompanied by the smell of gas.
• Flames lift away from burner, accompanied by the smell of gas, and possible lighting difficulties.
• Burner output on HIGH, but setting is LOW. Rumbling noise and fluttering blue flame at burner surface.
Possible causes
Propane – improper lighting procedure
Natural gas – undersized supply line.
Leaking gasket surrounding the ceramic tile, or a weld
failure in the burner housing.
Both gas propane and natural gas – improper preheating.
22
| Troubleshooting
N415-0601_Built In (Book).indb 22 N415-0601_Built In (Book).indb 22
TM outlet is dirty or clogged
Solution
Clean JETFIRE TM outlet with a soft bristle brush.
Clean or replace as required.
Replace with premium heavy- duty battery.
Check electrode wire is firmly pushed onto the terminal on the
back of the igniter. Check the lead wires from the module to the
ignition switch (if equipped) are firmly pushed onto their respective
terminals.
Close air shutter according to "Maintenance Instructions"-
Combustion Air Adjustment section in this Owner's Manual.
IMPORTANT! This must be done by a qualified gas installer.
Solution
This isn't a defect. It's caused by internal vibrations in the
regulator and doesn't affect the performance or safety of the grill.
Humming regulators WILL NOT be replaced.
Open cylinder valve slowly
Ensure sear plates are installed with holes towards the front, and
the slots on the bottom. See Assembly Instructions Guide.
Preheat grill with both main burners on high for 10 to 15 minutes.
Clean sear plates and drip pan regularly. Do not line pan with
aluminum foil. Refer to "Cleaning Instructions".
Solution
Ensure lighting procedure is followed carefully. All gas valves must
be in the OFF position when the tank valve is turned on. Turn tank
on slowly to allow pressure to equalize. See Operation – "Lighting
Instructions".
Pipe must be sized according to installation code.
Allow burner to cool and inspect very closely for cracks. Contact
your authorized Napoleon dealer to order replacement burner
assembly if any cracks are found.
Preheat grill with both main burners on high for 10 to 15 minutes.
Napoleon.com | BUILT-IN Series
2/11/2021 3:38:56 PM 2/11/2021 3:38:56 PM