Advertisement
4. Place the battery in a fireproof container
for charging, such as a Small LiPo Battery
Bag (#752-00015).
5. From the charger's main menu, use the arrow keys to scroll to
LiPo BATT
the
Enter/Start
key. (Section 5.1 of the User's Manual)
6. From the LiPo sub-menu, use the arrow keys to select the
Enter/Start
the
will have to make this selection every time you plug in your charger. (Section 5.3 of the User's
Manual)
7. To set the charge current, press the
Use the arrow keys to set the charge current. This example is for the 5300 mAh battery with a
max of 5.3A, but the charger max is 5.0A, so we will use 5.0A. For the 3300 mAh battery, you
would select a charge current below 3.3 A, such as 3.0A. Press the
the value.
8. The battery voltage (cell count) should now be flashing. Use
the arrow keys to set the voltage;
5300 and 3300 mAh three cell batteries. Press the
key again to save the value.
9. Press and hold the
The charger will automatically check the battery and display
the number of cells detected "R" and the number set by the
user "S". If the two numbers are identical, it will prompt you to
Enter/Start
press
10. As the battery is charged, the screen will display information
about the charge status. The charger will notify you when the
battery is fully charged.
Resources and Downloads
Check for the latest version of this document and for the manufacturer's user manual on the Tenergy
TB6B Balance Charger product page. Go to www.parallax.com and search 752-00009.
Revision History
Version 1.0 – Initial Release
Copyright © Parallax Inc.
program and select it by pressing the
key. Always use this mode; it will balance & charge your battery. Note that you
Enter/Start
11.1V(3S)
Enter/Start
key for at least two seconds.
to begin the charging process.
Tenergy TB6B (#752-00009)
BALANCE
key. The charge current should begin to flash.
Enter/Start
for both Parallax
Enter/Start
v1.0 2/11/2016 Page 3 of 3
program and select it with
key again to save
Advertisement
