Eurotops 45212 Instruction Manual

Eurotops 45212 Instruction Manual

Advertisement

MD719/ 1369
- Please read the Operating instructions carefully before handling the little LED-light-
emitting train.
- Please keep carefully the instruction manual for future reference.
- When you submit this article to third parties, give him the present instruction
manual.

A. PRODUCT DESCRIPTION

Locomotive (x1)

B. BATTERY INSTALLATION

Before inserting batteries, insure that the train is off (reset the switch to the
OFF position).
Unscrew the
Then, press black
screw which is
tab to remove the
to the back on
cover
the locomotive
on the battery
compartment
cover.

C. CIRCUIT SETUP

- Before proceeding to the setting up tracks, be sure that the floor surface is perfectly flat. The
circuit board must be placed on a clean stable flat surface, dust-free and non-fibrous (ex.
carpet fibers) so that the train can easily run straight through.
- If you mount the circuit on a table, be sure that the tracks are not closen to the edge of this
table. Because the cars could derail and fall in the empty space.
ELECTRIC CHRISTMAS TRAIN
INSTRUCTION MANUAL
Carriage A (x1)
Carriage B (x1)
Insert 2 batteries AA/
LR06 as indicated
inside the battery
box.
Carriage C (x1)
Reset the cover as
Screw the battery
indicated on the
cover back into
above drawing.
place. And be sure
that the screw has
been properly
tightened.
English
Tracks (x8)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 45212 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Eurotops 45212

  • Page 1 English MD719/ 1369 ELECTRIC CHRISTMAS TRAIN INSTRUCTION MANUAL - Please read the Operating instructions carefully before handling the little LED-light- emitting train. - Please keep carefully the instruction manual for future reference. - When you submit this article to third parties, give him the present instruction manual.
  • Page 2 1. Tracks layout setting up In order to snap, proceed as indicated hereunder DO NOT bend or damage the slots or the rails tabs. 2. Two options of forms of circuit Note: To obtain this form, do not use the below tracks: D.
  • Page 3 This symbol indicates that electrical and electronic devices are collected selectively. The symbol shows a waste container crossed out with an X symbol. Imported by EML/ Prodis 1 rue de Rome 93110 Rosny-sous-Bois-France/ Made in PRC Marketed by EUROTOPS VERSAND GMBH D-40764 LANGENFELD...

Table of Contents