Leds On Battery; Assembling The Trimmer; Mounting The Deflector; Stihl Autocut C 4-2 Mowing Head - Stihl FSA 65 Instruction Manual

7 Assembling the Trimmer

6.3

LEDs on Battery

The LEDs can show the state of charge or malfunctions. The
LEDs can glow or flash green or red.
The state of charge is indicated when the LEDs glow or flash
green.
► If the LEDs glow or flash red: Troubleshooting, @ 18.
Malfunction in trimmer or battery.
7 Assembling the Trimmer
7.1

Mounting the Deflector

► Switch off the trimmer, push retaining latch to position
and remove the battery.
1
2
The line limiting blade (1) is already installed in the deflector
(2) and must not be removed.
► Push the deflector (2) into the guides on the housing as far
as stop.
The deflector (2) is tight against the housing.
► Insert and tighten down the screws (3).
The deflector must not be removed again.
7.2

STIHL AutoCut C 4-2 Mowing Head

7.2.1 Mounting the Mowing Head
► Switch off the trimmer, push retaining latch to position
and remove the battery.
0458-284-9821-C
3
2
1
2
► Fit the mounting head (1) on the shaft (2).
► Rotate the spool (4) until the arrow heads on the spool and
mowing head (1) are in alignment.
► Fit the cap (3) in the spool (4) and tighten it down firmly by
hand (clockwise).
7.2.2 Removing the Mowing Head
► Switch off the trimmer and remove the battery.
► Hold the mowing head (2) steady and rotate the cap (1)
counterclockwise until it can be removed.
► Remove the cap (1) and mowing head (2).
English
3
4
1
1
2
35