Jandy Versa Plumb VPK-CVSTD Installation Instructions Manual

FOR YOUR SAFETY - ONLY the plumbing pieces in the Versa Plumb kits as shown in figures 3, 4,
and 5 are intended for "do it yourself" (DIY) homeowner installation. Any pool equipment such as
heaters, filters, pumps, etc. must be installed and serviced by a contractor who is licensed and quali-
fied in pool equipment by the jurisdiction in which the product will be installed where such state or
local requirements exist. In the event no such state or local requirement exists, the service provider or
maintainer must be a professional with sufficient experience in pool equipment service and maintenance
so that all of the instructions in this manual can be followed exactly. Before installing this product, read and
follow all warning notices and instructions that accompany this product. Failure to follow warning notices and
instructions may result in property damage, serious injury, or death. Improper installation and/or operation
will void the warranty.
These instructions are to be used with the following Versa Plumb Kits:
VPK-CVSTD -- CV Standard, Versa Plumb Kit
VPK-CVSLR -- CV Solar, Versa Plumb Kit
VPK-CSSTD -- CS Standard, Versa Plumb Kit
These instructions address the installation of the Jandy Pro Series Versa Plumb Kits only. In order to pre-
vent risk of electrical shock, carbon monoxide poisoning, explosion, or fire, which could result in property
damage, serious injury or death, installation and servicing of any pool equipment other than the Jandy Versa
Plumb Kits must be done only by a contractor who is licensed and qualified in pool equipment by the juris-
diction in which the product is installed where such state or local requirements exist. In the event no such
state or local requirement exists, the service provider or maintainer must be a professional with sufficient
experience in pool equipment service and maintenance so that all of the instructions in the specific products'
manual can be followed exactly.
1. Introduction
This document gives instructions to install and
plumb the Versa Plumb kit for your pool/spa equipment
pad.
The instructions were written with safety as the
priority and must be followed exactly. Not following the
written procedure or taking shortcuts may increase the
risk of personal injury. Read through the instructions
completely before starting the procedure.
Before starting the procedure, use the parts list at
the back of these instructions to identify the parts that
are in your kit. If any parts are missing from the kit
please call your local Jandy distributor for assistance.
Versa Plumb
Installation Instructions
WARNING
WARNING
For technical assistance, please contact our Technical
Support Department at 1.800.822.7933.
2. Ordering Information
To order or purchase parts for the Versa Plumb
system, contact your nearest Jandy dealer or distributor.
If they cannot supply you with what you need, call
Zodiac Pool Systems, Inc. at 1.800.822.7933. In
Canada call Zodiac Pool Systems Canada, Inc.
Customer Support Department at 1.888.647.4004.
Kits
®