Assembly - RIDGID R9500 Operator's Manual

18 volt combo, hammer drill, impact driver
Table of Contents

Advertisement

Available languages

Available languages

ASSEMBLY

R8611506 HAMMER DRILL
UNPACKING
This product requires assembly.
 Carefully remove the tool and any accessories from the
box. All items listed in the Includes section must be
included at the time of purchase.
WARNING:
Items in this Assembly section are not assembled
to the product by the manufacturer and require
customer installation. Use of a product that may
have been improperly assembled could result in
serious personal injury.
If any parts are damaged or missing, please call
1-866-539-1710 for assistance.
WARNING:
If any parts are damaged or missing do not operate
this product until the parts are replaced. Use of
this product with damaged or missing parts could
result in serious personal injury.
WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended
for use with this product. Any such alteration
or modification is misuse and could result in a
hazardous condition leading to possible serious
personal injury.
R86039 IMPACT DRIVER
WARNING:
Do not use this product if it is not completely
assembled or if any parts appear to be missing or
damaged. Use of a product that is not properly and
completely assembled or with damaged or missing
parts could result in serious personal injury.
If any parts are damaged or missing, please call 1-866-539-1710 for assistance.
Includes: Hammer drill, auxiliary handle assembly
INSTALLING/REMOVING THE AUXILIARY
HANDLE
See Figures 1 - 2, page 12.
An auxiliary handle is included for ease of operation and to
help prevent loss of control. The handle can be mounted for
left or right hand use. It may also be installed in a vertical
position as shown.
To install the auxiliary handle:
 Remove the battery pack.
 Turn the handle grip counterclockwise to loosen it and
open the hooks wide enough to fit over the mounting ribs,
behind the torque adjustment ring.
 Place the hooks over the mounting ribs, making sure the
tabs are positioned in the slots as shown.
NOTE: Make sure the slots on the inside of the auxiliary
handle engage the tabs on the drill housing.
 Turn the handle clockwise to tighten. Make sure the
handle is secure before beginning operation.
To remove the handle and install it on the opposite side:
 Turn the handle grip counterclockwise to loosen and
remove the handle.
 Reinstall the handle in the desired position.
WARNING:
Do not attempt to modify this product or create
accessories not recommended for use with this
product. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
6 - English

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

R8611506R86039Octane r8611506313582516

Table of Contents