A.O. Smith ST1302 Manual page 40

38
Level 2
• Opposite end: Place the long end of the
shaft on the wood block. Place the bear-
ing (and other parts as used, such as
snap rings and washers) over the short
end of the shaft. Tap the bearing into
place using the proper size tube and a
mallet, or use a press. Attach any other
parts (as used) to the short shaft end.
Compare the rotor and shaft parts assembly
shown on the previous pages with the order of
assembly found on the motor during teardown.
The miscellaneous parts (washers, snap rings,
etc.) vary from motor to motor, so when disassem-
bling use care to identify these parts and their
order so they can be reassembled in the proper
sequence.
Pump Motors
A.O.Smith