Page 1
Digital Projector WX20 Product Safety Guide WX20 Projecteur numérique - Guide de Sécurité de Produit WX20 Digitalprojektor - Sicherheitsanleitung des Geräts WX20 Proyector digital - Guiá de Seguridad del Producto WX20 Proiettore digitale - Guida di Sicurezza del Prodotto WX20 Digitale Projector - Veiligheidsgids op Product WX20 Projector Digital - Guia da Segurança de Produto...
Retain these instructions for future reference. Intended Use The 3M™ Digital Projectors are designed, built, and tested for use indoors, using 3M lamps, 3M ceiling mount hardware, and common line voltages (100V to 240V AC, 50/60 Hz). The use of other replacement lamps, outdoor operation, or different voltages has not been tested and could damage the projector, peripheral equipment and/or create a potentially unsafe operating condition.
Page 6
Do not modify this projector. Do not attempt to service the projector - there are no user serviceable parts, other than the lamp cartridge, inside the projector. Contact a 3M authorized service provider for service. Do not allow water or other liquids to enter the projector.
Page 7
Do not mix used and new batteries. Obey the local laws on disposing the battery. Use only the 3M™ brand wall/ceiling mounting hardware kit if wall or ceiling mounting is desired. Adhere strictly to the proper installation procedure as outlined in the installation instructions when installing the 3M™...
For recycling and disposal information, contact your respective governmental agencies. In U.S., contact 1-800-328-1371 (3M US) or the Electronic Industries Alliance at www.lamprecycle.org In Canada, contact 1-800-364-3577 (3M Canada)
Do not attempt to service the projector - there are no user serviceable parts, other than the lamp cartridge, inside the projector. Contact a 3M authorized service provider for service. Unplug the projector from the electrical outlet and allow the lamp to cool for 45 minutes before replacing the lamp.
Page 12
Tighten the lamp module retaining screws (3) to secure the lamp module in place. Tighten the screw Optional Lamp: 78-6969-9946-1 Reset the lamp operation hours. See “Reset Lamp Hours” for details. (1) Screw 3M™ Digital Projector WX20 Product Safety Guide Note Note (Contact 3M Customer Service.) (DT00821)
3M’s option, to replace or repair the 3M product or to refund the purchase price of the 3M product. All replaced parts or products become property of 3M. If the product is repaired, 3M will repair the defective part(s) with a new or used part(s). If the product is replaced, 3M will replace the product with the same or equivalent model and with a new or refurbished product.
Need help?
Do you have a question about the WX20 and is the answer not in the manual?
Questions and answers