Table of Contents
Advertisement
c. Unable to Adjust Setpoint Setting to Obtain Tripping
Improper air gap between Hold-down (lower) Magnet and Armature.
Return the Vibraswitch to the factory for repair.
d. Switch Does Not Actuate
Defective or improperly adjusted switch - (Ref. Figure 4-1).
Manually move the Armature between the hold down magnet (armed position) and latching magnet (latched position)
and listen for an audible click of the switch. An audible click occurs when contacts change state. Verify by perform-
ing a continuity check. Return the Vibraswitch to the factory for repair.
If the switch does not pass either of the tests above, return the
Vibraswitch to the factory for repair.
N O T E
Page 18
909GF299
Advertisement
Table of Contents
