Nash Siren R3 User Manual page 4

When turned off LEDs light sequentially from right to left with a
sequence of decreasing pitch bleeps.
Tone:
The R3 Receiver replicates the tone of each R3 head it is
programmed to.
Volume: Short press of the Volume button. Four volume settings
are available. Each consecutive short press of the Volume
button changes volume output by one level. The bleep you hear
represents the volume being set.
Recall Last Event: Short press of the Power button. This allows
you to check which alarm registered an indication even if you
missed the illuminated LED on the receiver and R3 head. The
LED that corresponds to the R3 alarm that last registered an
indication will light and pulse for ten seconds.
Vibrating Alert and Mute: Short press of V button. Each short
press scrolls through the four modes available.
Vibrate and LED flash: Receiver muted, vibrate and LEDs on.
LED flash only: Receiver muted. LEDs on. No sound and no
vibrate.
Beep, LED flash and Vibrate: Sound, LED and vibration turned
on.
LED flash and a bleep: Sound and LEDs on.
Anti-Theft Alarm: Long press of A Button on Receiver. Two
bleeps will be heard. An increasing pitch signifies Anti-Theft
is ON. Decreasing pitch is Anti-Theft OFF. Factory setting is
Anti-Theft OFF.
The Anti-Theft alarm alerts you if an R3 head is turned off
whilst your Receiver is on. Once triggered, a long press of the A
button on the Receiver stops the alarm sounding.
P4 SIREN R3 USER MANUAL
2020 SIREN R3 USER MANUAL 25.02.20.indd 4 13/07/2020 08:41