Advertisement
Quick Links
Operations Manager OM12xx, OM22xx, OM12xx-L, and
REGISTER
This Quick Start Guide covers basic installation and configuration of the OM1200 and OM2200. For in-
depth guidance, consult the Operations Manager User Manual.
Register your product:
When you register, you:
•
Activate your warranty
•
Get notified when firmware updates are released. For licensing information and access to source
code visit:
and OM22xx-L
https://opengear.com/product-registration
https://opengear.com/software-licenses
2020-May
Advertisement
Related Manuals for Opengear OM12 Series
Summary of Contents for Opengear OM12 Series
- Page 1 OM22xx-L REGISTER This Quick Start Guide covers basic installation and configuration of the OM1200 and OM2200. For in- depth guidance, consult the Operations Manager User Manual. Register your product: https://opengear.com/product-registration When you register, you: • Activate your warranty •...
-
Page 2: What's In The Box
WHAT’S IN THE BOX? 1 x OM1200 or OM2200 Device 1 x 450031 – Power supply 1 x OM1200 Rackmount Kit 1 x 319015 - Cisco straight pinout RJ45 to DB9F crossover serial adapter 1 x 440016 - 5ft/1.5m Cat 5 RJ45 to RJ45 UTP straight cable Cellular Enabled Units 2 x 569041 –... - Page 3 LOG IN WebUI Using a computer connected to the same subnet, open your browser and type in https://IPaddress of the device to access the WebUI. To log in the first time, use the username root and password default. NOTE: During your first log in, you will be directed to change the root password. Command Line Interface (CLI) The unit can also be accessed through an SSH client using the device IP address over port 22.
-
Page 4: Basic Configuration
BASIC CONFIGURATION Serial Ports CONFIGURE > Serial Ports By default, all serial interfaces are enabled with the following settings: • Pin Out – X2 • Baud Rate – 9600 • Data Bits – 8 • Parity – None • Stop Bits – 1 Local Console In all Operations Manager OM1200 units, serial port 1 must be enabled as the local console port. - Page 5 System firmware can either be upgraded via HTTP/HTTPS Server or by uploading the file to the device CONFIGURE > System > System Upgrade The latest firmware is located here: http://ftp.opengear.com/download/operations_manager/current/ Factory Reset Devices can be set to factory default by navigating to CONFIGURE > System > Factory Reset.