G) Data Logger - VOLTCRAFT Energy Control 3000 Operating Instructions Manual

• After the installation, you can start the "Energy Professional" program via an icon on the
desktop or via the relevant program menu.
• You will find the program description in the Help menu.

g) Data Logger

• All measuring values transmitted by the sensors are stored in the memory of the "Energy
Control 3000 USB".
• With each value, the associated time information is also stored.
• The memory capacity level is shown in the memory graphic indicator at the lower edge of
the display.
Meaning of the indicator:
No field filled:
1 field filled:
2 fields filled:
3 fields filled:
3 fields filled, 4th field is blinking:
4 fields filled:
• The recording duration depends on the number of installed sensors. If only one energy
sensor is received, up to 108 days can be recorded; with 2 sensors 54 days are possible,
and at a "full load" with 12 sensors, you can still store data for 9 days.
• These data can be read at any time via the USB interface (back, below) and the software.
If the data are not read in this way, the oldest data in the memory are successively
overwritten with new data. This overwriting is done in blocks.
62
Fill level in the range of 0-24%
Fill level in the range of 25-49%
Fill level in the range of 50-74%
Fill level in the range of 75-89%
Fill level in the range of 90-99%
Memory full (100%)