Alternate Mode malletKAT User Manual page 91

REASSIGN MINIMUM VELOCITY
REASSIGN MAXIMUM VELOCITY
The following Global Screens are described in the Real Time Controller(https://alternatemode.com/online-
docs/malletkat/#rtc-real-time-controller)
Section
RTC KEY NUMBER
RTC CHANNEL
RTC CONTROLLER#
RTC MIN VALUE
RTC MAX VALUE
RTC RESET VALUE
RTC PREV CNTRL VALUE
RTC NEXT CNTRL VALUE
RTC CONTROLLER #
RTC RESET VALUE
SLEW DATA STRIP RATE
Global Auxiliary Shortcut #12
malletKAT Express
Auxiliary Editing Screens require pressing the Edit Footswitch and Sustain 1 pedal at the same time (See Section
4.1.1(https://alternatemode.com/online-docs/malletkat/#malletkat-express-accessing-editing-functions)
)
SCREEN ANGLE
Parameters = Straight View, Edge View
You can change the viewing angle of the screen from Straight View to Edge View.
Global Auxiliary Shortcut #03
malletKAT Express
Auxiliary Editing Screens require pressing the Edit Footswitch and Sustain 1 pedal at the same time (See Section
4.1.1(https://alternatemode.com/online-docs/malletkat/#malletkat-express-accessing-editing-functions)
)
SELECT DATA DUMP TYPE
Parameters = Global, All Memory, All Kits, Chains & Reassignments, User KITS K01-128 Use the Inc/Dec pads to
decide which Type of Memory Dump you want to send. Strike the Global Pad again (D natural). The malletKAT
will immediately send out the data dump. The malletKAT will automatically accept a data dump without any setup
from the user as long as the Data Dump Receive Enable (screen #04) is set to Enable. This is the default setting.
91 / 109
malletKAT User Manual (ver.07-17-18)