Operation; Switching On/Off; Switching On; Switching Off - Bosch 1 687 023 850 Series Original Instructions Manual

en 16 | 1 687 023 850 – 858
5.

Operation

5.1

Switching on/off

5.1.1

switching on

i
Always allow a waiting time of up to three minutes in
the following situations:
$
Between switching the PC off and on at the multi-
ple socket outlet (not recommended).
$
Between switch-off and switch-on using the ON/
OFF switch at the PC power supply unit (back of
PC).
i
The wait time is shortened if the power key on the
front is used for switching on and off.
1. Supply the product with power.
Switch on the multiple socket outlet on the trolley or
connect the PC directly to the power supply.
2. Switch on the PC via the on/off switch on the back
of the PC.
 The operating system starts up.
i
The computer can then be switched off and on via
the power key on the front of the PC.
5.1.2

Switching off

1. End all programs.
2. Select "Start >> Shutdown".
 The operating system shuts down.
 The PC switches off automatically.
i
Alternatively, the computer can be switched off and
on via the power key on the front of the PC.
|
1 689 989 347 2018-02-08
5.2

Instructions in case of faults

i
Contact Customer Service if any problem cannot be
rectified employing the remedies listed below.
5.2.1

Display

Fault
No display. The monitor re-
mains blank.
No display. The monitor re-
mains blank although the PC
is switched on.
5.2.2

Enter

Fault Remedy
Keypad input not func- Make sure the keypad is properly con-
tioning. nected to the PC.
Release any sticking keys and clean the
keypad or replace following the ingress
of liquid and in the case of persistent
problems.
Mouse input not func- Make sure the mouse is properly con-
tioning. nected to the PC.
5.2.3

Reproduction

Fault Remedy
No sound reproduc- If the monitor has integrated louds-
tion. peakers, make sure the monitor audio
input is connected to the audio output
of the PC.
Make sure the sound function has be-
en activated in the system settings.
No reproduction of da- Make sure the CD/DVD is clean, exhi-
ta from CD/DVD. bits no major damage (scratches etc.)
and is inserted the right way round in
the drive.
Remedy
Make sure the PC and all other
components are being supplied
with power.
Make sure the multiple socket
outlet at the trolley has been
switched on.
Make sure all connecting cables
and the power cord are connec-
ted to the monitor.
Check the monitor settings
(brightness, contrast, alignment
etc.).
Robert Bosch GmbH