Initial Commissioning; Unpacking; Installation And Connection; Software Installation - Bosch PC2018 Original Instructions Manual

en 14 | PC2018
4.

Initial commissioning

4.1

Unpacking

1. Unpack the PC.
2. Check the scope of delivery.
3. Dispose of the packaging materials in the proper
manner.
4.2

Installation and connection

i
The PC is supplied already installed and connec-
ted in most Beissbarth GmbH products. Proceed
as described below if a PC has to be installed on
commissioning or if an existing PC is to be replaced.
Otherwise this Section can be ignored.
1. Disconnect the PC from the power supply.
2. Remove the covers.
3. Disconnect the connecting cables from the previous
PC.
4. Remove the previous PC.
5. Fit the new PC.
6. Connect the connecting cables to the new PC.
7. Fit the covers.
4.3

Software installation

4.3.1

Operating system

i
The WIN 10 operating system is factory-installed.
1. Supply the product with power.
2. Switch on the multi-point connector.
3. Switch on the On/Off switch on the back of the PC.
4. Switch on the PC by way of the Standby button.
 The operating system starts up.
 The language settings are displayed.
5. Select the local language.
i
Optionally, after the national language has been
selected, additional settings such as apps language,
keyboard layout or time zone can be set.
6. Read and follow the instructions on the screen.
 The PC is ready for operation.
4.3.2

Software

The software (e.g. BEA-PC, FSA, ESI[tronic], EPS) is
supplied with the product. If the software is not pre-
installed, it must be installed using the data carrier pro-
vided with the product.
|
1 690 706 055 2018-05-03
5.

Operation

5.1

Switching on/off

5.1.1

switching on

i
Always allow a waiting time of up to three minutes in
the following situations:
$
Between switching the PC off and on at the multi-
ple socket outlet (not recommended).
$
Between switch-off and switch-on using the ON/
OFF switch at the PC power supply unit (back of
PC).
i
The wait time is shortened if the power key on the
front is used for switching on and off.
1. Supply the product with power.
Switch on the multiple socket outlet on the trolley or
connect the PC directly to the power supply.
2. Switch on the PC via the on/off switch on the back
of the PC.
 The operating system starts up.
i
The computer can then be switched off and on via
the power key on the front of the PC.
5.1.2

Switching off

1. End all programs.
2. Select "Start >> Shutdown".
 The operating system shuts down.
 The PC switches off automatically.
i
Alternatively, the computer can be switched off and
on via the power key on the front of the PC.