3Com 3CRWER300-73 User Manual page 43

L2TP mode
The Layer Two Tunneling Protocol (L2TP) provides a standard method for
transporting the link layer of the Point-to-Point Protocol (PPP) between a
dial-up server and a Network Access Server, using a network connection
in lieu of a physical point-to-point connection. This mode is most often
used in Israel. To set up the Router for use with a L2TP (Layer 2 Tunneling
Protocol) connection, use the following procedure:
Figure 27 L2TP Screen
1 Enter the L2TP Server information.
2 Enter the User ID and Password required by your ISP.
3 Retype the password.
4 Enter the maximum Idle Timeout for the Internet connection. After this
time has been exceeded the connection will be terminated.
5 Check the Get IP By DHCP box to receive IP address from your ISP's DHCP
function. If this box is not checked, enter the IP address, Subnet mask,
and Default Gateway information on the corresponding fields.
6 Check all of your settings, and then click Next.
The LAN Settings screen will then be displayed (refer to
Accessing the Setup Wizard
Figure
41
28).