Table of Contents
Advertisement
20
C
2: I
HAPTER
NSTALLING THE
Using the Rubber
Feet
Wall Mounting
Mounting
Instructions for
Cement Walls
R
OUTER
When positioning your Router, ensure:
It is out of direct sunlight and away from sources of heat.
■
Cabling is away from power lines, fluorescent lighting fixtures, and
■
sources of electrical noise such as radios, transmitters and broadband
amplifiers.
Water or moisture cannot enter the case of the unit.
■
Air flow around the unit and through the vents in the side of the case
■
is not restricted. 3Com recommends you provide a minimum of
25 mm (1 in.) clearance.
Use the four self-adhesive rubber feet to prevent your Router from
moving around on your desk or when stacking with flat top units. Only
stick the feet to the marked areas at each corner of the underside of your
Router.
Please be careful when you put 3COM Router on top of another unit, if
the unit underneath is hot, this may impact the reliability of 3Com Router.
There are two slots on the underside of the Router that can be used for
wall mounting. The Router must be mounted with the LEDs facing
upwards.
When wall mounting the unit, ensure it is within reach of the power
outlet. When wall mounting the unit, ensure that the rubber feet are not
fixed.
To wall mount the unit:
1 Make two holes 100 mm (3.9 in.) apart and insert two nylon or similar
screw anchors that are suitable for the wall construction.
2 Fix two suitable screws into the anchors, leaving their heads 3 mm (0.12
in.) clear of the wall surface. The screws should be at least 30 mm (1.2
in.) long.
3 Remove any connections in the Router and locate it over the screw heads.
When in line, gently push the Router on to the wall and move it
downwards to secure.
Advertisement
Table of Contents
