3Com IntelliJack NJ2000 Quick Start Manual page 10

6. Connect the NJ2000 to the Network
The method for connecting the NJ2000 to the network is determined by how
the network cable is terminated, as described in step 5.
If the end of the cable is terminated with a female RJ-45 connector, use
•
one of the RJ-45 coupler cables included in the NJ2000 package to
connect the NJ2000 to the network cable.
If the end of the cable is terminated with a male connector, connect the
•
network cable directly into the Ethernet uplink port.
7. Mount the NJ2000 to the Wall
After you connect the NJ2000 to the network, follow these steps, as shown in
the next figure:
Mount the NJ2000 to the wall-mount bracket.
1
CAUTION: Make sure that the vents along the edges of the NJ2000 faceplate
are clear of any obstructions to allow airflow to vents.
Slide the NJ2000 onto the wall-mount bracket, ensuring that the 4 hooks
2
on the bracket fit into the 4 slots on the back of the NJ2000.
Pull the NJ2000 down to lock the hooks tightly into the slots. Be sure to
3
match the screwholes in the bracket and the NJ2000. Secure the NJ2000
using the T-10 torx screw that came in the NJ2000 package
10