To Clear All Error Code; To Exit From Self-Diagnostic Function; Power Amplifier Failure (F61); Description Of Error Code - Panasonic SA-AK230GC Service Manual

3. Press to close the tray.
4. Press "CD DIRECT PLAY (5)" and
5. Press and remove the CD.
6. Press to close the tray.
7. Press "n/STOP" to indicate Error Code.
· If several problem exist, error code will change each time when "n/STOP" is pressed. (e.g. F15 → F26 → F16 ....etc).

11.5. To clear all Error code

1. Press and hold button for 5 seconds.
2. FL indicator shows "CLEAR" for 1 second and change to "T".

11.6. To exit from Self-Diagnostic function

1. Press button on main unit or remote control.

11.7. Power Amplifier Failure (F61)

1. When power amplifier fail, F61 will indicate automatically.

11.8. Description of Error Code

11.8.1. Abnormality detection for Deck Mechanism block
No. Abnormal Items
1 MODE SW abnormal
2 REC INH SW abnormal
3 HALF SW abnormal
4 Reel pulse abnormal
11.8.2. Abnormality detection for CD/Changer block
No. Abnormal Items
1 REST SW abnormal
2 Transmission error between CD servo
LSI and micon
3 CLAMP SW abnormal
4 BOTTOM SW abnormal
5 POSITION SW abnormal
6 SW1 abnormal
7 SW2 abnormal
8 OPEN SW abnormal
9 CLOSE SW abnormal
10 DISC SENSOR
wait until the tray is open.
Error Display Method of Detection
H01 Normal operation during mecha transition, MODE SW abnormal is
memorized. The content of abnormality can be confirmed in the
abnormal detection mode explained in the later section.
H02 The content of abnormality can be confirmed in the abnormal detection
mode explained in the later section.
H03 The content of abnormality can be confirmed in the abnormal detection
mode explained in the later section.
F01 The content of abnormality can be confirmed in the abnormal detection
mode explained in the later section.
Error Display Method of Detection
F15 Under normal operation (Self-Diagnostic Mode inclusive), this error
occurs when the REST SW ON is not detected within the specified time
and shall be memorized.
F26 Under normal operation (Self-Diagnostic Mode inclusive), this error occurs
when the selection is set to CD and SENSE='H' is detected and
SENSE='L' is not detected within a fail safe time (20ms) after system
command transmission was sent.
F16 Refer to section 11.8.4 (Mechanism Error Code Table) [M-0A] error is
detected.
F17 Refer to section 11.8.4 (Mechanism Error Code Table) [M-09] error is
detected.
F27 Refer to section 11.8.4 (Mechanism Error Code Table) [M-05 ~ M-08] error
is detected.
F28 Refer to section 11.8.4 (Mechanism Error Code Table) [M-02 ~ M-08] error
is detected.
F29 Refer to section 11.8.4 (Mechanism Error Code Table) [M-02 ~ M-08] error
is detected.
H15 Refer to section 11.8.4 (Mechanism Error Code Table) [M-01] error is
detected.
H16 Refer to section 11.8.4 (Mechanism Error Code Table) [M-01] error is
detected.
F30 Refer to section 11.8.4 (Mechanism Error Code Table) [M-01] error is
detected.
43
SA-AK230GC / SA-AK230GN