Advertisement
Antenna installation
The Minima 6S antenna system is made for high directivity consisting of two antennas.
In order to secure the clear range, please install Minima 6S antenna as shown below.
TX
TX
RX
TX
TX
Receiver Connection Diagrams
Glow, Gas, Nitro or Electric-Powered Aircraft Using a Separate Receiver Battery
Use this method on electric planes using ESCs providing power to the receiver and
servo functions
2.4GHz 6 Channel
2.4GHz 6 Channel
Aircraft Receiver
Aircraft Receiver
2.4GHz 6 Channel
2.4GHz 6 Channel
Aircraft Receiver
Aircraft Receiver
Link (ID-Setting)
- Link must be done within 15ft(5m). of the transmitter and receiver.
- Transmitter and receiver need to be at least 18in(50cm).
from each other to link properly.
Note
Hitec RCD Korea, Inc. (43, Yangcheong 3-gil, Ochang-eup, Cheongwon-Gu, Cheongju-si, Chungcheongbuk-do, Korea) / www.hitecrcd.com / Made in the Philippines
Recommended installation
method to optimize
receiver performance
90 ˚
Too Far: More than 5M(15ft)
Too Close: Less than 50Cm(18in)
Link (ID-Setup or Bind)
Your Hitec AFHSS system uses a communication protocol that links and binds the Hitec
2.4GHz receiver to your transmitter. Once the receiver and module are "bound," no other
transmitter can interfere with your receiver during its operation. In the case of multiple
model memory transmitters, you can bind as many Hitec
2.4GHz receivers to your transmitter, one per model memory as necessary.
Each module and receiver set is paired at the factory for your convenience.
Use one of the following binding methods to bind additional Hitec 2.4GHz receivers to
your transmitter.
ID-Setup A.K.A, Link or Bind
Non-telemetry RXs (MINIMA 6S)
Press and hold the
button on the
module and
turn on the
transmitter.
Release the link button.
Check if BLUE LED is blinking.
If RED LED is blinking, press
the link button for 2 sec., so
that LED changes to the BLUE.
Press and hold the link button on the
Receiver and turn on the power.
BLUE LEDs on the Receiver will blink rapidly
to find the transmitter signal.
Release the link button when the
BLUE LED on the receiver glows steady.
When the link is completed,
the BLUE LED on the module
will blink.
To save the setting, please reboot both the
Transmitter and Receiver
When they are turned on again,
the RED LED on the Radio
and the BLUE LED on the
Receiver will glow steady.
Advertisement
