Emerson EAD30E1 Owner's Manual page 8

PARTS AND FEATURES
6) Bucket Full - When the water bucket is full of water, the unit will automatically shut off, make a beeping noise, and the
Bucket Full Indicator will light up. The dehumidifier will not function until the water bucket is emptied and placed back
inside the unit. The bucket should be cleaned every few weeks to prevent the growth of mold, mildew and bacteria. Use
a mild detergent to clean the bucket. Once clean, completely dry the bucket and place it back inside the dehumidifier.
NOTE: Hold bucket with both hands when emptying.
NOTE: When the bucket is full or removed from the machine, the compressor will turn off, but the fan will continue to
run for a few minutes. This is completely normal. The dehumidifier will not be removing moisture from the air at this
time.
NOTE: When removing moisture from the air, the dehumidifier will exhaust warm air from the side exhaust vent.
NOTE: Do not place a full bucket on the floor, because the bottom is uneven.
7) Clean Filter- When the filter needs to be cleaned, the filter indicator will light up (after 250 hours of use). Remove the
filter from the back of the unit by using your thumbs to press down on the filter tabs directly above the filter. Clean the
filter with warm, soapy water. Dry thoroughly before replacing the filter. Once the filter is completely dry, place the filter
back in the unit and press the
FILTER button to reset the filter indicator.
CAUTION: DO NOT OPERATE THE DEHUMIDIFIER WITHOUT THE FILTER
NOTE: Do not clean filter in dishwasher