Maintenance - Emerson EAD30E1 Owner's Manual

• Place dehumidifier on a level surface.
• Unscrew the cap on the back of the unit to access the garden hose nozzle
• Thread a garden hose (not supplied) onto the accessible nozzle, lead to a floor drain and cut to length. Make sure that
there are no kinks or knots in the garden hose. (See picture below) Turn on the unit and press the MODE button until set
to CONTINUOUS.
Garden Hose Installation Reference Guide
IMPORTANT NOTES:
Placing the dehumidifier on an uneven surface or improper hose installation may result in water filling up the bucket and
causing the unit to shut off. Empty bucket if shutoff occurs, then check dehumidifier location and hose for proper setup.
The bucket must be in place and securely seated for the dehumidifier to operate.

MAINTENANCE

Note: Make sure power is off and the power cord is not plugged into an electrical outlet prior to performing any
maintenance on the unit.
Clean or Replace Filter - Refer to Operating Instructions Clean Filter section
Clean the Unit Housing-
1) Keep the unit from being exposed directly to the sun to prevent color fading.
2) Clean the surface with a damp cloth and dry it with a soft towel.
Storing the Unit for an Extended Period of Time or Transporting the Unit
1) Clean or replace filter- Refer to Operating Instructions Clean Filter section
2) Turn off and unplug the unit
3) Empty any excess water
4) The unit should be stored in a cool & dry place.