Error Code - Emerson EAD30E1 Owner's Manual

Problem Possible Causes
Frost appears on • The dehumidifier has recently been
the coils turned on or the room temperature is
below 41 °F(5°C).
Controls cannot be • The compressor will turn off and the
set fan will automatically continue to run
for approximately 3 minutes at a fixed
setting.
• Air is moving through the unit.
Water on the floor • Hose connection may be loose.
• Hose is attached but not draining

ERROR CODE

Error Code
EH
El or E2
E3
For any questions or Technical Support,
Please call customer service:1-844-882-2622
Or email: serviceweb@canac.ca
Description
Humidity Sensor Fault
Temperature Sensor Fault
Lack of gas
Solutions
• This is normal. Frost will usually disappear within
60 minutes.
• This is normal. Wait approximately 3 minutes and
set the fan speed at the desired level.
• This is normal.
•
Check the hose connection.
CONTINUOUS MODE-GARDEN HOSE INSTALLATION
AND SET UP Section.
• Disconnect the hose if using the bucket; place
the hose near a drain.
See the