3Com 4500G Getting Started Manual page 48

48 C 3: S
HAPTER ETTING
U M
P FOR ANAGEMENT
2 Press Enter to open a login prompt.
If the login prompt does not begin immediately, press Return a few times
until it starts.
3 At the login and password prompts, enter admin as your user name and
press Return at the password prompt. If you have logged on correctly,
<4500G> is displayed as shown in the example in Figure 28.
Figure 28 User View Login using Telnet
4 Enter the system-view command and Enter.
5 Enter interface vlan 1 and Enter.
6 Enter the IP address and subnet mask for the switch as follows:
ip address xxx.xxx.xxx.xxx mmm.mmm.mmm.mmm
(where
xxx.xxx.xxx.xxx
subnet mask of the switch)
7 Enter the default gateway for the switch:
ip route-static 0.0.0.0 0.0.0.0 xxx.xxx.xxx.xxx
(where xxx.xxx.xxx.xxx is the IP address of the default gateway)
8 Enter the save command to save the configuration to your switch as the
configuration is not saved automatically when the switch is powered down.
The initial set up of your switch is now complete and the switch is ready for
you to set up your chosen management method. See "Methods of
Managing a Switch" on page 36.
is the IP address and is the
mmm.mmm.mmm.mmm