Download Print this page

Battery Usage - Gemmy LEDLIGHTSHOW 1002019 Instructions Manual

Wireless remote controller, living projection projector

Advertisement

BATTERY USAGE:

Required 2 AAA batteries (included).
1.Keep these instructions for future reference because they contain important information. 2. May explode or leak and cause
burn injury if recharged, disposed of in fire, mixed with a different battery type, inserted backwards or disassembled. 3.
Products that contain batteries should not be disposed of in fire. The batteries inside may explode or leak. 4. Do not mix
alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries. 5. Do not mix old and new batteries. Replace all
batteries of a set at the same time. 6. Use only batteries of the same or equivalent type as recommended by the manufacturer.
7 . Be sure to insert batteries with correct polarities and always follow manufacturers' instructions. 8. Remove exhausted
batteries from product promptly. 9. Do not short-circuit supply terminals. 10. Remove batteries before storage or extended
periods of non-usage. 11. Clean the contacts on the batteries and the device prior to battery installation. Non-rechargeable
batteries are not to be recharged. Rechargeable batteries are not recommended for use in this product. If rechargeable
batteries are being used, however, please follow these guidelines. (1).Rechargeable batteries should be removed from the
product before being charged. (2). Rechargeable batteries should only be charged under adult supervision.
IMPORTANT SAFETY INSTRUCTIONS
When using electrical products, basic precautions should always be practiced including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
1.
2. Read and follow all instructions that are on the product or provided with the product.
3. Do not use an extension cord.
4. Reference the National Electrical Code, ANSI NFPA 70, specifically for the installation of wiring and clearances from
power and lighting conductors.
5. Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and
standards, including fire-rated construction.
6. Do not install or use within 10 feet of a pool.
7 . Do not use in a bathroom.
WARNING:
8.
receptacle that is weatherproof with the power unit connected to the receptacle. If one is not provided, contact a
qualified electrician for proper installation. Ensure that the power unit and cord do not interfere with completely closing
the receptacle cover.
WARNING:
9.
structure. Consult a qualified electrician.
10. If the connector of this driver does not properly fit into the connector of the lighting string, do not modify the product
and discard product if the connector is damaged.
WARNING:
11.
(attachment plug cap not inserted and receptacle cover closed).
SAVE THESE INSTRUCTIONS -
instructions for power units.
CAUTION
1. For temporary (90 days max.) installation and use only.
2. To reduce the likelihood of excessive heat and possible damage, use only decorative lamp accessories packaged with this
product or marked for use with this product.
3. To reduce the risk of fire or electric shock, do not attempt to replace lamps or modify wiring or product.
4. This is an eletric product-not a toy. To avoid risk of fire, burns, personal injury and electric shock it should not be played or placed
where small children can reach it.
5. Do not connect to another lighting string, decorative outfit or seasonal product.
6. Always unplug this product before installing or replacing fuses.
Risk of Electric Shock.
Risk of Fire.
Installation involves special wiring methods to run wiring through a building
Not for use with receptacles that are weatherproof only when the receptacle is covered
When used outdoors, install only to a covered Class A GFCI protected
This manual contains important safety and operating
E-5

Advertisement

loading

This manual is also suitable for:

Ledlightshow 448093