Transport; Transport Wheels - ZIPPER MASCHINEN ZI-RAM80C User Manual

Transport

ALWAYS shutdown engine before transporting.
Tighten fuel tank cap securely and close fuel cock to prevent fuel from spilling.
Drain fuel when transporting rammer over long distances or bad roads.
When placing the rammer inside a truck-bed for transport, always tie-down the
rammer
If possible always transport the tamper in an upright position. However it is important to ensure that
the unit may not fall over. If this is impossible lie the tamper and lashed firmly to prevent rolling or
moving.
 Always turn off the engine when transporting
 Close fuel cock (K) and (c) to prevent fuel leaks
 Empty the fuel tank if the transport way is very long
 To lift the tamper use always the transport hanger (J)

Transport wheels

The transport wheels facilitate the transport over short distances.
 Turn off the engine.
 Tilt the tamper forward and slide the axis of the wheels (N) into its holder.
 Secure the axis with the foot, tilt the tamper back on the axle and proceed using the guide bracket.
 To remove the transport wheel proceed in reverse order
The unit is heavy and may not be lifted by a single person. Using only with 2 persons. Use the
transport wheels only on firm, level ground and for short distances. The transport wheels must
be removed before the next compacting..
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-RAM80C
A C H T U N G
NOTE
MAINTENANCE
33