3Com MSR 20-20 Release Note page 16

3Com MSR Family Release Notes
Release Notes Software v5.20
| <5> Change Ethernet Parameter
| <6> Exit To Main Menu
| < Ensure The Parameter Be Modified Before Downloading! >
=============================================================
Enter your choice(1-6):5
3 Select option 5 (Change Ethernet Parameter) to change the download parameters, as shown
in the example below.
Note: To modify the parameter values, enter the new values next to the existing values. Do not
use the Delete or Backspace key to erase the existing values.
Note: Two protocols for download, tftp & ftp.
You can modify the flags following the menu except the boot
device.
tftp--0x80, ftp--0x0.
'.' = clear field;
boot device
processor number
host name
file name
inet on ethernet (e) : 172.16.1.1
inet on backplane (b):
host inet (h)
gateway inet (g)
user (u)
ftp password (pw) (blank = use rsh):
flags (f)
target name (tn)
startup script (s)
other (o)
Table 5: Description on the download parameters
Parameter
Download boot device
Download file name
Target file name
Inet on ethernet
Host inet
Gateway inet
4 When the Ethernet SubMenu is re-displayed, select option 2 (Update Main Application File)
to download and write the application image to Flash memory. Depending on the running
code, the system display would look something like:
Attached TCP/IP interface to mottsec0.
'-' = go to previous field;
: mottsec0
: 0
: host
: msr50-cmw520-b1508p01-si.bin
: 172.16.1.254
:
:
: 0x80
:
:
:
Description
The Ethernet port for downloading; leave the default as is. The
physical port is usually the first Ethernet port(Eth 0/0 or GigE
0/0)
Name of the image file to be downloaded.
File name to be used on the router. If left blank, the current
filename for that application type will be used
IP address of interface eth0.
IP address of the server where the image is stored.
You must configure the gateway address if the server and the
router are not located on the same segment.
|
|
|
Ctrl+D = quit
16