Installing Cage Nuts; Installing Mounting Ears - Huawei IVS1800 User Manual

IVS1800 Video Management System
User Manual
5.
6.
7.
Issue 02 (2021-01-27)
Figure 3-10 Installing cage nuts
Install mounting ears. Use a PH2 screwdriver to secure the mounting ears to
both sides of the front panel of the device with four screws on each side.
When the device is near the front door of the cabinet, fasten screws in hole
groups 1 and 2; when the device is near the rear door, fasten screws in hole
groups 2 and 3.
Figure 3-11 Installing mounting ears
Install the IVS1800 in the cabinet.
1. Lift the device from both sides and carefully position it at the front of the
cabinet.
2. Lift the device slightly above the guide rails, gently place it on the guide
rails, and then slide it into the cabinet until the mounting ears of the subrack
contact the mounting bars at the front of the cabinet.
Thread M6 screws (prepared by the customer) through two slotted holes on
each mounting ear. Fasten the M6 screws using a Phillips screwdriver to fix
the mounting ears on the front mounting bars of the cabinet, as shown in the
lower right figure.
Copyright © Huawei Technologies Co., Ltd.
3 Installing an IVS1800
14