Installing An Ivs1800; Install Hard Disks; Removing The Hard Disk Tray - Huawei IVS1800 User Manual

IVS1800 Video Management System
User Manual
Context
By default, the IVS1800 is delivered without disks. After the IVS1800 is delivered to
the site, install hard disks as required and then install the IVS1800 in the cabinet.
Procedure
Step 1 Install hard disks.
1.
2.
3.
Issue 02 (2021-01-27)
Use a PH2 screwdriver to remove the two black screws on the rear of the
chassis cover, and take off the chassis cover.
Figure 3-1 Removing the chassis cover
Remove two black screws on each side of the chassis and the silvery white
one on top of the hard disk tray, raise the hard disk tray by 45 degrees, and
take out the upper and then lower layers of hard disk tray.
Figure 3-2 Removing the hard disk tray
Place the hard disks with ports facing upwards and align the screw holes on
the hard disk tray with the hard disks and fasten the screws. Before the
installation, ensure that the fastener of the hard disk tray is on a different
side from the hard disk port, as shown in the lower left figure.
Copyright © Huawei Technologies Co., Ltd.
3

Installing an IVS1800

3 Installing an IVS1800
10