Nordic IMPULSE Owner's Manual page 5

DANGER- Risk of electric shock
CAUTION – Risk of Electric Shock- do not leave
compartment door open.
CAUTION – Risk of Electric Shock- replace components only
with identical components.
WARNING – Prevent Electrocution:
• Do not connect any auxiliary components (for example
cable, additional speakers, headphones, additional audio/
video components, etc.) to the system.
• Do not permit electric appliances (such as a light,
telephone, radio, or television) within 1.5M (5 ft) of this hot
tub
• These units are not provided with an outdoor antenna;
when provided, it should be installed in accordance with
Article 810 of the National Electrical Code, ANSI/NFPA 70.
• Do not service this product yourself as opening or
removing covers may expose you to dangerous voltage
or other risk of injury. Refer all servicing to qualified
service personnel.
• When the power supply connections or power supply
cord(s) are damaged; if water is entering the audio/video
compartment or any electrical equipment compartment
area; if the protective shields or barriers are showing signs
of deterioration; or if there are signs of other potential
damage to the unit, turn off the unit and refer servicing to
a qualified service personnel.
• This unit should be subjected to periodic routine
maintenance (for example, once every 3 months) to make
sure that the unit is operating properly.
Please read through this again and SAVE THESE INSTRUCTIONS
WARNING: When using this electrical equipment, basic
safety precautions should always be followed, including the
following:
• A green colored terminal or a terminal marked G, GR,
Ground, Grounding, or with the
inside the supply terminal box or compartment. To reduce
the risk of electric shock, this terminal must be connected
to the grounding means provided in the electric supply
service panel with a continuous copper wire equivalent in
size to the circuit conductors supplying this equipment.
• At least two lugs marked "BONDING LUGS" are provided
on the external surface or on the inside of the supply
terminal box or compartment. To reduce the risk of
electric shock, connect the local common bonding grid
in the area of the hot tub or spa to these terminals with an
insulated or bare copper conductor not smaller than No.
6 AWG (13 mm2).
• All field-installed metal components such as rails, ladders,
drains or other similar hardware within 1.5 m(5 ft) of
the spa or hot tub shall be bonded to the equipment
grounding bus with copper conductors not smaller than
No. 6 AWG (13 mm2).
CAUTION: TEST THE GROUND FAULT CIRCUIT
INTERRUPTER BEFORE EACH USE OF THE SPA.
(we care about your safety!)
symbol is located
NORDIC HOT TUBS | OWNER'S MANUAL
5
|