Nordic IMPULSE Owner's Manual page 12

POWER INSTALLATION INSTRUCTIONS
120 VOLT CORD CONNECTION OPTION
The cord connection option is only available for 120V operation on the models rated 12/15 A. Only the manufacturer
recommended power cord and GFCI should be used for cord connected installations. Only plug the cord into a dedicated
120V/15 amp receptacle after following the steps below.
Electrical installation should be performed by a qualified, licensed electrician.
Warning: Make sure that cord is unplugged from the wall socket prior to proceeding with the following steps.
1. Remove cabinet service panel. The panel is secured with Phillips Head truss machine screws.
2. Remove system controller cover.
3. If spa was manufactured with a cord, disconnect cord wires from
terminal TB1 and ground wire from ground bar.
4. Loosen cord strain relief.
5. Remove cord.
6. Remove strain relief.
7. Drill hole for conduit through bottom or side of spa.
8. Secure conduit at system controller box.
9. Connect hot and neutral wires to corresponding terminals TB1.
Connect ground wire to grounding bar on the outside of box by
running it though hole marked for ground wire. Double check that all
electrical connections are tight.
10. Reinstall system cover and hot tub access panel.
WARNING: DO NOT TURN ON POWER UNTIL TUB IS FILLED COMPLETELY WITH WATER!
Suction Fittings
Whirlpool Jet
Waterfall Jet
12
| NORDIC HOT TUBS |
HOT TUB ANATOMY
Air Controls
Cup Holders
Air Controls
Filter
OWNER'S MANUAL
(110-all-in, Classic and Modern Series)
Topside Control
Access Panel (side of cabinet)
CONTINUED
Air Controls
Cup Holders
Light
Ozone Jet
Cup Holder
Air Controls