Installation; Changing The Installation Method - Kenwood DM-VH7 Instruction Manual

Installation

10
The front feet attached at the factory can be replaced with the provided replacement feet.
When you want to stack the RD-VH7 (optional) above this unit, installed this unit horizontally by using
the provided horizontal installation spacer.
Check the following accessories
Replacement front feet .................................... 2
Spacer for horizontal installation.................... 1
Allen wrench ..................................................... 1

Changing the installation method

Horizontal, stacked installation (When stacking the optional RD-VH7 above the unit)
Use the provided spacer for horizontal installation.
1
Attach the spacer by inserting its claws into the
spacer mount holes on the rear of the this unit.
NOTE When inserting the claws, align them
with the holes by tilting the spacer slightly
(about 20 degrees) as shown in the illus-
tration.
Spaser
Claw
Vertical installation
Change the left front foot location as described below.
1
Using the Allen wrench, remove the 2 screws
from the front foot located on the left when
the unit is seen from the front.
1
Step
Spaser mount
hole
Front feet removed in step 1
÷ Remove the MD and unplug the power cord be-
Notes Notes Notes
fore proceeding to the following operation.
÷ Only the front feet can be replaced.
÷ When attaching replacement front feet, use only
the screws which have been used with the re-
moved feet. (Using other screws may result in a
fire or malfunction.)
÷ If this unit is fell down by mistake after installation
and if an MD is left inside the unit, the MD may be
damaged.
2
Arrange the cords by winding them around
the spacer.
The audio cords and system control cord can be
accommodated into the trench on the spacer by
winding them as shown in the illustration.
3
Stack the RD-VH7 by aligning its feet with the
foot support cavities on the spacer.
2
Align the removed front foot with the
threaded holes on the rear part of the right
side panel, and attach the front foot using the
screws removed in step 1.
2
Step
DM-VH7 (EN)
View of the unit
when it is placed
vertically