Step 1
Carefully remove the passenger side A Pillar cover.
2
Tab I
Step 2
The antenna should be located on the passenger side of the
front windscreen. Ensure that there is an approximate 15cm
gap at the top of the antenna film and a 7cm gap from the side
of the windscreen to the vertical strip of the antenna film as
shown.
Wipe the inside of the windscreen where the antenna film and
the antenna earth and amplifier block is to be located with the
cleaner.
Note: If the glass is cold you will need to warm the glass by
using the cars heater. This will ensure a good adhesion.
Step 3
Ensure that the glass surface is completely dry before
mounting the antenna film.
Remove Tab I on the antenna film and stick the lower
horizontal section of the antenna film to the windscreen.
Ensure you have left a 15cm gap at the top and 7cm gap to the
side.
Note: Remove the backing gently and do not touch the sticky
side of the horizontal section of the antenna film