Using The Security Lock - Toshiba TDP-S1-US User Manual

M a i n t e
30
n a n c e &
8 Align the new lamp module in the correct direction.
9 Gently push the module in as far as it goes.
10 Tighten the screws on the outside of the module.
11 Slide the lamp connector to the left to re-attach it.
12 Insert the tabs at the top of the lamp door into the projector
and press the lamp door into place.
13 Plug in the power cord and turn the projector back on.
14 To reset the lamp hour counter in the Status window, press
and hold the left mouse button, then press the menu button
(while still holding down the mouse button) for 5 seconds.
Verify that the counter was reset by pressing the menu button
and viewing the counter in the Status window.

Using the Security Lock

The projector has a security connector for use with a PC Guardian
Cable Lock System (Figure 23). Refer to the information that
came with the lock for instructions on how to use it to secure the
projector.
F 23
IGURE
Installing the security lock
T r o u b l e s h o o t i n g