Before Calling Service - Toshiba SDP95S Owner's Manual

Before calling service

Check the following guide for the possible cause of a problem before contacting service.
Symptom Cause
No power. • The AC adapter is disconnected.
• Battery empty.
The battery cannot be • The battery is near full charge.
charged.
The LCD turned off by • The automatic LCD off function turned the
itself. LCD off.
No picture on the LCD • The AV OUT jack is connected.
monitor.
No picture. (Other than • The connected TV is not set to receive DVD
built-in LCD monitor) signal output.
No sound. • The equipment connected via the audio/video
cable is not set to receive DVD signal output.
• The volume is too low.
• The audio receiver or TV is turned off.
The playback picture has • The disc is dirty.
occasional distortion.
• Player is in fast forward or fast reverse mode. • Sometimes a small amount of picture distortion may appear. This is
• The player was moved or given a shock.
• The disc is not set firmly.
Brightness is unstable or • The effect of copy protection. If you connect
noises are present in the the player to a VCR, TV/VCR combination
playback pictures. (Other or video selector, the playback picture may
than built-in LCD monitor) be distorted as DVD video discs are copy
protected.
68
SDP95SWN_E_53-80.indd 68 SDP95SWN_E_53-80.indd 68
Correction
• Connect the AC adapter securely.
• Re-charge the battery.
• Retry charging after using the battery power.
• Turn on the player again.
• When you use the LCD of the player, unplug the AV OUT jack.
• Select the appropriate video input mode on the TV so the picture from
the player appears on the TV screen.
• Select the correct input mode of the audio receiver so you can listen
to the sound from the player.
• Adjust the volume.
• Turn on the equipment connected with the audio/video cable.
• Eject the disc and clean it.
not a malfunction.
• Vibrating or shaking the player during playback may produce
distortion. This is not a malfunction. If not restored to usual status, stop
playback and start again.
• Remove the disc and set it again.
• Connect the player directly to the TV. Avoid connecting the player to a
VCR or TV/VCR combination.
2011/02/01 11:17:10 2011/02/01 11:17:10