Getting Started - VTech Fix & Learn Car Carrier Parents' Manual

WARNING:
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties and packaging screws are not part of this
toy and should be discarded for your child's safety.
NOTE:
Please keep this parent's guide as it contains important information.

GETTING STARTED

The unit is in try-me mode in the packaging. To exit try-me mode, place
the car on the car carrier first, then insert the green or grey accessory
part to the front of the car and turn the screw. When you hear the
opening short tune, this means you gave entered normal mode. If the
Off/Mode Selector is in OFF position, just slide it to turn the unit on.
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on
the bottom of the unit and use a
screwdriver to loosen the screw
and open the battery cover.
3. Remove old batteries by pulling up
on one end of each battery.
4. Install 2 new AA size (LR6/AM-
3) batteries following the diagram
inside the battery box.
5. Replace the battery cover and
tighten the screw to secure.
5