Lan Port Inspection; Total Assembly Adjustment; Compensate Auto Keystone; Used Device - LG PF1500 Service Manual

8. LAN port Inspection

8.1. Equipment setting
(1) Play the LAN Port Test PROGRAM.
(2) Input IP set up for an inspection to Test Program.
- IP number : 12.12.2.2
8.2. LAN PORT inspection
(1) Play the LAN Port Test Program.
(2) Connect each other LAN Port Jack.
(3) Play Test (F9) button and confirm OK Message.
(4) Remove LAN CABLE
<Adjustment for Assembly Line>

9. Total Assembly Adjustment

9.1. Enter Power Only mode
(1) After assembling the SET, DC on the SET at the start of
post process. (use keypad or remote controller)
(2) Press 'P-ONLY' key of the adjustment remote controller to
enter 'Power Only' mode. (Full White screen is displayed)
(3) To enter the next adjustment, enter 'EXIT' of the remote
controller to exit Full white screen, and proceed to the
adjustment.
(PING TEST)
(PING TEST)
- 10 -

10. Compensate Auto Keystone

10.1. Used Device

- Adjustment remote controller
- Projector remote controller
10.2. Adjustment Preparations and Device
Configuration
(1) Adjustment Preparations
1) Input source: Default ( no need to specify an input
2) The set must be adjusted on a plate, glass or table with
a flatness degree between more than -1 and less than
+1.
3) Incline upward the set to project an image over the top
line of the screen. After the keystone changes, adjust
the image to the adjusting position. (Fig. 10-2-1)
(Fig. 10-2-1) Preparations before Auto Keystone Compensation
(2) Adjustment Method
1) Make sure the set is placed on an adjusting position.
2) Check the keystone value using the projector remote
control.
A. Enter the Menu button.-> Move through the
options.-> Check the Keystone value.
3) Enter the menu to compensate the keystone using the
adjustment remote controller.
A. ADJ -> 24. Auto Keystone ADJ -> Enter the right
arrow key
(Fig. 10-2-2) Auto Keystone Menu
source)