Advertisement
Table of Contents
Installation
Ripples requires a -12V/+12V power
supply (2x5 pin connector). The red
stripe of the ribbon cable (-12V side)
must be oriented on the same side
as the "Red stripe" marking on the
module and on your power distribu-
tion board.
The module draws 35mA from both
the +12V and -12V supply rails.
Calibration
If necessary, adjust the trimmer on
the left side of the module so that
Ripples
the tone emitted by the fi lter (when it
self-oscillates) tracks a CV sent to the
V/OCT CV input.
Liquid fi lter
Online manual and help
The full manual can be found online at
mutable-instruments.net/modules/
ripples/manual
For help and discussions, head to
mutable-instruments.net/forum/
Please refer to the online manual
for detailed information regarding
compliance with EMC directives
Advertisement
Table of Contents
Related Manuals for Mutable Instruments Ripples
Summary of Contents for Mutable Instruments Ripples
- Page 1 Installation Ripples requires a -12V/+12V power supply (2x5 pin connector). The red stripe of the ribbon cable (-12V side) must be oriented on the same side as the “Red stripe” marking on the module and on your power distribu- tion board.
- Page 2 Controls Cutoff frequency. Filter slope. The lower position corresponds to a 12 dB/octave slope (2-pole), the upper position to a rounder 24 dB/octave (4-pole). The BP and LP outputs are affected. Resonance. Goes up to self-oscillation. Input 1 level, with a tasty analog soft-clipping.
Need help?
Do you have a question about the Ripples and is the answer not in the manual?
Questions and answers
how to issue fuel