Connecting To A Digital Amplifi Er/Av Receiver; Connecting To Network - Toshiba BDX2250KU Owner's Manual

Connections
Connecting to a digital amplifi er/AV receiver
Route the sound from this player to other device to enhance audio output.
• Connect a coaxial cable from the COAXIAL DIGITAL jack on this product to the COAXIAL jack on the device.
• If your AV receiver or amplifi er has an HDMI jack, you can also connect the HDMI cable to HDMI IN jack on your AV
receiver or amplifi er.
digital audio coaxial cable

Connecting to network

Your Blu-ray Disc™ player can be connected to your home network:
• By connecting an Ethernet cable to the ETHERNET jack on the rear of your player and to a wired hub or router. Using
a wired network provides the best performance, because the attached devices connect directly to the network and
are not subject to radio frequency interference.
• By connecting through the built-in wireless device and a wireless access point or router.
Connecting your player to a wired router
• Connect an Ethernet cable (CAT5 or better with RJ45 connector) to the
and to an Ethernet jack on a hub or broadband router.
Networking equipment
(modem, etc.)
LAN
LAN cable
Internet
DIGITAL AUDIO INPUT
COAXIAL
(not included)
Hub or broadband router
WAN
5 4 3 2
LAN cable
LAN
AV receiver / amplifier
ETHERNET jack on the back of your player
Notes:
• Do not connect a modular
p h o n e c a b l e t o t h e
ETHERNET jack.
LAN
• When plugging or unplugging
the cable, hold the connector
1
on the end of the cable.
When unplugging, do not
pull on the cable. Press down
the lock tab and pull the
connector out of the jack.
• Because there are various
connection configurations,
follow the instructions from
your telecommunication
carrier or Internet service
provider.
11