Ignition Coil Resistance Test (continued)
Ignition Coil Installation
Electrical System: Service and Repairs
3. The volt Ohm meter should read 1.3-1.7 Ohms.
Secondary
1. Remove the spark plug cap from the high tension wire by holding the wire
and unscrewing the cap by turning counter-clockwise.
2. Place one lead of the meter in the end of the high tension lead.
3. Place the other lead on the coil frame.
4. The volt Ohm meter should read 5.4-6.2 Ohms.
1. Install the ignition coil onto the engine.
Figure 270
Figure 271
Page 8–10
1P65F-2 Service Manual
3429-270 Rev A