Setup; Assembling And Unfolding The Handle - Toro 20955 Operator's Manual

Setup

Important:
Remove and discard the protective
plastic sheet that covers the engine and any other
plastic or wrapping on the machine.
Important:
To prevent accidental starting,
do not insert the electric-start button into the
electric-start ignition (if equipped) until you are
ready to start the engine.
1
Assembling and Unfolding
the Handle
No Parts Required
Procedure
1. Remove and save the 2 handle knobs and 2
carriage bolts from the handle brackets
3).
1. Handle knob (2)
2. Install the handle ends onto the mower housing
so that the pin attached to each handle bracket
is in the lower hole of its related handle end
(Figure 4).
Figure 3
2. Carriage bolt (2)
1. Pin
Note:
in the handle ends when the handle is in the
folded position.
3. Unfold the handle to the operating position by
rotating it rearward
(Figure
1. Operating position
4. Insert the carriage bolt (with the bolt head toward
the inside) through the upper or lower square
hole in handle bracket and the upper hole in the
handle end
g032865
6
Figure 4
2. Handle end
The pins do not show through the holes
(Figure 5).
Figure 5
2. Folded position
(Figure 6).
g032866
g032868