G-Link ™ Connection - Toshiba 27HLV95 Owner's Manual

™
G-LINK connection
• This connection is necessary for the TV Guide On Screen™ system to work with your cable box to receive program listings and to
enable the TV Guide On Screen™ recording features with your VCR.
After you connect your devices to the TV, you will need to connect the G-LINK
included with your TV) from your VCR and Cable box (if applicable) to the G-LINK
Note: TV Guide On Screen™ program data is available through the ANT-1 and ANT-2 antenna inputs and also through the VIDEO 1 inputs if you
have a cable box connected to VIDEO 1. TV Guide On Screen™ program data is not available through any other inputs on this TV. See the
connection information on pages 15–24.
The G-LINK ™ connection is necessary to enable the following features of your TV Guide On Screen
• If you have a Cable box, you need to connect the G-LINK
the TV Guide On Screen ™
• If you have a VCR, you need to connect the G-LINK
On Screen ™ recording features.
™
To connect to the G-LINK
1. Locate the infrared sensor on the front of your VCR or
Cable box. The sensor is marked on some devices.*
2. Align one of the G-LINK
1 inch away from the infrared sensor on the front of the
VCR and attach it using double-sided mounting tape.
If you have a Cable box, attach the other wand in a similar
manner. (See illustration at right.)
Note: If you do not have a Cable box, coil the second wand
with a rubber band and leave it behind the TV.
3. Plug the G-LINK ™ (IR blaster) cable's plug into the TV's
G-LINK ™ terminal.
For details on setting up the TV Guide On Screen
See Chapter 5.
For details on using the TV Guide On Screen
program guide:
See Chapter 7.
*
If you cannot locate the device's infrared sensor:
1. Turn OFF the device.
2. Starting at the lower left corner of the device, place the end of the
device's remote control (with the infrared emitter) so it touches the
front of the device and press POWER. (Do not use the TV's remote
control for this step.)
3. If the device turns on, the point at which the remote control touched
the device is the location of the sensor.
4. If the device does not turn on, move the remote control slightly to the
right and press POWER again.
5. Repeat step 4 until you locate the device's infrared sensor.
Chapter 2: Connecting your TV
program listings for your Cable service.
™
cable from the VCR to the G-LINK
terminal:
™
(IR blaster) cable's wands about
™
system:
™ interactive
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
™
cable (either of the dual-wand IR blaster cables
™
terminal on the TV.
™
cable from the Cable box to the G-LINK
Front of Cable box
Front of VCR
Infrared
sensor
G-LINK™ (IR blaster) cable wand
(approx. 1 inch from device)
TV lower back panel
™ system:
™
terminal to receive
™
terminal to use the TV Guide
23