Connecting A Vcr And Satellite Receiver With Colorstream (Component Video) - Toshiba 27HLV95 Owner's Manual

Connecting a VCR and satellite receiver with ColorStream
You will need:
one signal splitter
four coaxial cables
one set of component video cables
one pair of standard audio cables
two sets of standard A/V cables
• For better picture performance, if your VCR have S-video, connect
S-video cables (plus the audio cables) instead of the standard
video cables. Do not connect both types of video cable to VIDEO 1
at the same time or the picture performance will be unacceptable.
• If you have a mono VCR, connect L/MONO on the TV (VIDEO 1)
to your VCR's AUDIO OUT terminal using the white audio cable
only.
To view satellite programs using the component video
connections:
Select the ColorStream HD video input source on the TV.*
To view the VCR or view and record antenna channels:
Turn ON the VCR. Select the ANT-1 video input source
on the TV.* Tune the TV to channel 3 or 4 (whichever
channel is vacant in your area).
or... Turn ON the VCR. Tune the VCR to the channel you
want to watch. Select the VIDEO 1 video input source on
the TV.*
_____________
*
To select the video input source, press INPUT on the remote control
(see page 60). To program the TV remote control to operate other
devices, see Chapter 3.
To use the TV Guide On Screen
1. Connect the G-LINK™ cable according to the
instructions on page 23.
2. Make sure the VCR is connected to the A/V OUT
terminals on the TV (see illustration).
3. Set the VCR to the appropriate line input (refer to your VCR
owner's manual for details), and then turn OFF the VCR.
4. See Chapter 5 for details on setting up the TV Guide
™
On Screen system.
5. See Chapter 7 for details on using the TV Guide
™
On Screen system.
Note: The TV Guide On Screen™ system does not receive program
listings from or for any satellite service.
18
Chapter 2: Connecting your TV
™
recording features:
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
®
From antenna
IN
Signal splitter
OUT OUT
VIDEO
CH 3
CH 4
TV lower back
panel
From satellite dish
Y
P P
B R
Satellite
IN
S-VIDEO COMPONENT VIDEO
OUT
Satellite receiver
Note: The VIDEO/AUDIO OUT terminals output signals from the ANT 1,
ANT 2, VIDEO 1, and VIDEO 2 terminals when the appropriate input mode
is selected. The playing disc's contents by the DVD section are not output.
The unauthorized recording, use, distribution, or revision of television
programs, videotapes, DVDs, and other materials is prohibited under the
Copyright Laws of the United States and other countries, and may subject
you to civil and criminal liability.
(component video)
Stereo VCR
AUDIO
L R
IN from ANT
IN
OUT to TV
OUT
L R
TV upper back panel
AUDIO
OUT
L L
R R
VIDEO
OUT