Download Print this page

Sealey LED3606 Series Quick Start Manual page 2

Rechargeable 360 inspection lamp 24smd led + 3w led 2 x lithium-ion

Advertisement

4.2.
Use of lamp
Warning: Ensure that the lenses are not pointing in a dangerous direction before switching on.
4.2.1.
To switch the lamp on, press the function switch (fig.1) to select the required function:
1st push: top light
2nd push: front light, low output
3rd push: front light, high output
4th push: off
4.2.2.
When the lamp is switched on, the charge level will be shown by the number of green charge lights illuminated, three being a full
charge.
4.2.3.
If only one green light is showing, the lamp requires recharging.
4.2.4.
To employ the 360° function, pull the base downward to release the ball joint. The lamp can then be positioned in any attitude relative
to the base. Alternatively the back magnets or 360° hooks may be used.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
BATTERY REMOVAL
Remove the 6 screws on the back of the lamp. Remove the back casing and disconnect the wiring from the circuit board. Remove the
battery mounting screws. Dispose of according to local government
Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of prod-
ucts containing batteries (as defined within these regulations), that they are registered with Valpak's registered compliance scheme.
Jack Sealey Ltd Batteries Producer Registration Number (BPRN) is BPRN00705.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
01284 703534
sales@sealey.co.uk
Original Language Version
guidelines.
www.sealey.co.uk
LED3606 series Issue: 1 - 07/03/18

Advertisement

loading