Sealey LED3606 Series Quick Start Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to instruction
manual
1. SAFETY
1.1. GENERAL
Ensure the lamp is fully charged before initial use.
9
DO NOT turn the lamp on when it is being charged.
8
DO NOT shine directly into your, other persons' or animals' eyes.
8
DO NOT allow children to use the lamp.
8
DO NOT handle or move the lamp whilst it is being charged.
8
DO NOT use the lamp if you suspect that the battery or the lamp casing is damaged.
8
DO NOT LEAVE BATTERY IN A DISCHARGED STATE, RECHARGE BATTERY IMMEDIATELY. BEFORE STORAGE,
8
FULLY RECHARGE THE BATTERY, SUBSEQUENTLY RECHARGE THE BATTERY AT LEAST ONCE EVERY SIX MONTHS OF
NON-USE.
1.2. BATTERY SAFETY
WARNING: To reduce the risk of burns or fire:
‰
DO NOT Attempt to open, dismantle, modify or service the battery pack.
8
DO NOT Crush, puncture, short external contacts or dispose of in fire or water.
8
DO NOT Expose to temperatures above 60°C (140°).
8
Replace only with the battery pack designated for this product.
9
Recycle or dispose of used battery as stipulated by local regulation.
9
If the electrolyte in the cells gets on your skin, wash thoroughly with soap and water. If it gets in your eyes, rinse thoroughly with cool
water and seek immediate medical attention.
2. INTRODUCTION
Positioned in any direction. Exclusive patented design owned by and registered to Sealey. Features 24 super bright SMD LEDs with magnified
lens providing up to 1000 lumens output with 120° spread of light, illuminating the whole work area. Includes an additional high power 3W LED
directional lamp. Features two swivel hooks and three rubber covered magnets, two on the rear and one on the end, which allow hands-free
operation. Two high quality 3.7V 2.6Ah Lithium-ion batteries in parallel for up to 15 hours run time. Micro USB charging port. Supplied with USB
cable.
3. SPECIFICATION
Model No: ....................................................LED3606 series
Battery: ................................................3.7V 2.6Ah Li-ion (x2)
LED Qty: ..................................................... 24 SMD + 1 LED
Lumen Output: ......... Side(High/Low)/Top - (1000/300)/150lm
Operating Time: ................. Side(High/Low)/Top - (3/12)/15hr
Charging Time: .................................................................7hr
IP Rating: ........................................................................IP54
Minimum Length: ........................................................ 256mm
Maximum Length: ....................................................... 276mm
4. OPERATION
4.1. Charging
4.1.1. To charge the lamp: insert the micro USB plug on the
USB cable into the charging port on the back of the
lamp (fig.1).
4.1.2. Plug the other end of the USB cable into a 5V USB
outlet.
4.1.3. The charge indicator lights (fig.1) will light in sequence
to show the current level of charge, each charge level
being shown by a flashing green before becoming solid.
4.1.4. Three solid green lights denote a full charge, at which point the lamp should be disconnected from the power supply.
© Jack Sealey Limited
RECHARGEABLE 360° INSPECTION LAMP
24SMD LED + 3W LED 2 x LITHIUM-ION
LED3606 SERIES
MODEL NO:
fig.1
Original Language Version
LED3606 series Issue: 1 - 07/03/18