Sealey LED136 Instructions

thank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
refer to
instruction
manual
1. safetY
1.1. general
it is important to ensure that the lamp is fully charged before initial use.
9
do not turn the lamp on when it is being charged.
8
do not shine directly into your, another person's or an animal's eyes.
8
do not allow children to use the lamp.
8
do not leave battery in a discharged state. recharge battery immediately.
8
recharge the battery at least once every six months of non-use.
1.2. electrical safety for use of charger.
use only the supplied charger or in-car charger for connecting the lamp to the power supply.
9
Warning! it is the user's responsibility to read, understand and comply with the following instructions:
‰
You must ensure the risk of electric shock is minimised by the installation of appropriate safety devices e.g. rcd.
9
if the lamp is used in the course of business duties, it must be maintained in a safe condition and routinely PAt (Portable Appliance
9
test) tested.
You must ensure that you inspect the charger plug, cable and connections for wear and damage to ensure items are safe before
9
connecting them to the mains power supply. if worn or damaged do not use.
Warning! do not use any other type of charger with this product, other than the supplied mains cable. failure to observe this
‰
warning could result in injury and or fire. The use of any other type of charger will invalidate the warranty.
there are no user serviceable components. do not dismantle.
for indoor use only. do not allow the charger to become wet. do not use in wet or damp conditions.
do not pull the charger plug from the mains socket by the lead.
8
1.3. battery safety
Warning! To reduce the risk of burns or fire:
‰
do not Attempt to open, disassemble, modify or service the battery pack.
8
do not Crush, puncture, short external contacts or dispose of in fire or water.
8
do not expose to temperatures above 60°c (140°).
8
replace only with the battery pack designated for this product.
9
recycle or dispose of used battery as stipulated by local regulation.
9
if the electrolyte in the cells gets on your skin, thoroughly wash with soap and water. if it gets in your eyes, rinse thoroughly with cool
9
water and seek immediate medical attention
2. introduction
robust design with built-in spring loaded telescopic mounting brackets. soft padded hooks provide good protection against the bonnet. An
adjustable light source with 40 smd leds give complete engine bay illumination. foldable design for easy storage when not in use. includes
battery level indicator, mains charger and in-car charger.
3. specification
model no ................................................................... led136
Battery ........................................................7.4V-2.2Ah li-ion
led Quantity ............................................................. 40 smd
lumen output ............................................................ 1400lm
min./max. ........................................................ 1230/1680mm
charging time ...................................................................6hr
operating time (low/high) ......................................... 1.5/3hrs
© Jack sealey limited
instructions for:
foldable under-bonnet cordless 40 smd
led rechargeable lamp - lithium-ion
led136
model no:
Original Language Version led136 | issue1 15/05/17