Advertisement
Opening the Rear Hood
Note: Ensure that the forward hood is open before opening
the rear hood.
1. Grasp the front edge of the rear hood.
2. Pull up firmly on the hood to unseat it from the hood
clips (Figure 1).
3. Rotate the hood up (Figure 1).
2
Connecting the Battery Cable
No Parts Required
Procedure
1. Verify that the positive (red) cable clamp is securely
connected to the positive post of the battery (Figure 2).
1. Negative cable clamp
2. Negative battery post
3. Negative battery cable
(black)
4. Front of the machine
Figure 2
5. Nut
6. T-bolt
7. Positive cable clamp (red
cable)
2. Align the clamp of the negative (black) cable to the
negative post of the battery (Figure 2).
3. Fully seat the terminal onto the post (Figure 2).
4. Torque the nut (Figure 2) and the T-bolt for the
negative cable clamp to 678 to 791 N-cm (60 to 70
in-lb).
3
Checking the Battery Voltage
No Parts Required
Procedure
1. Insert the machine key into the key switch and rotate
the key switch to the Run position.
2. Wait 5 minutes and note the voltage shown on the
LED display.
Note: Refer to the battery charge table to determine
the charge state of the battery.
3. If the charge state of the battery (indicated in the LED
display) is less than 12.6 volts, charge the battery; refer
to the Operator's Manual for charging instructions.
Battery Charge-state Table
Volts
12.7 and above
12.7 to 12.6
12.6 to 12.4
12.4 to 12.2
12.2 to 12.0
Below 12.0
2
Battery State
100% charge
85 to 100% charge
75 to 85% charge
50 to 75% charge
25 to 50% charge
Fully discharged
Advertisement
